Aproximación a la vulnerabilidad sísmica de las edificaciones mediante SIG: la serie sísmica de la Vega de Granada (2020-2021) = Approach to the seismic vulnerability of buildings through GIS: the seismic series of the Vega de Granada (2020-2021).
DOI:
https://doi.org/10.20868/ade.2022.5019Palabras clave:
vulnerabilidad sísmica, catastro, IGN, terremotos, SIG, seismic vulnerability, cadastre, NGI, GIS, earthquakesResumen
La Vega de Granada es una de las comarcas españolas que presenta una mayor peligrosidad sísmica, donde se han registrado importantes eventos con intensidad macrosísmica (Io)≥VIII. A final de 2020 comenzó una serie sísmica (aún activa, en marzo de 2021), que ha alcanzado una Io=V-VI. En el marco de los estudios de riesgo sísmico, es necesario conocer la vulnerabilidad de las edificaciones. Así, esta investigación persigue estimar unos valores relativos de vulnerabilidad de las edificaciones. Para ello, partiendo de información proveniente de Catastro y del Instituto Geográfico Nacional, así como de las fechas de normativas sismorresistentes, se ha llevado a cabo un análisis multicriterio. Para la integración de los datos, los cálculos, la representación y el análisis de los mismos se ha empleado un sistema de información geográfica gratuito. Los resultados muestran que, principalmente, la zona oeste de Santa Fe es la que podría verse más afectada.
Abstract
La Vega de Granada is one of the Spanish regions with the highest seismic hazard, where important events with macroseismic intensity (Io)≥VIII have been recorded. At the end of 2020 a seismic series began (still active, in March 2021), which has reached an Io=V-VI. In the framework of seismic risk studies, it is necessary to know the vulnerability of buildings. Thus, this research aims to estimate relative vulnerability values of buildings. For this purpose, a multi-criteria analysis was carried out based on information from the Cadastre and the National Geographic Institute, as well as on the dates of seismic-resistant regulations. A free geographic information system was used for data integration, calculations, representation and analysis. The results show that the area west of Santa Fe is the most likely to be affected.
Descargas
Referencias
S. Ahmari, K. Parameswaran, L. Zhang, Alkali activation of copper mine tailings and low-calcium flash-furnace copper smelter slag. J. Mater. Civ. Eng. 27(6), (2015) 04014193.
K.S. Al-Jabri, M. Hisada, S.K. Al-Oraimi, A.H. Al-Saidy, , Copper slag as sand replacement for high performance concrete (2009).
ASTM, ASTM C373 – Test Method for Water Absorption, Bulk Density, Apparent Porosity, and Apparent Specific Gravity of Fired Whiteware Products. American Society for Testing and Materials (1994a.).
A. Baziz, N. Bouzidi, D. Eliche-Quesada, Recycling of gold mining reject from Amesmessa mine as ceramic raw material: microstructure and mechanical properties. J. Environ Sci Pollut Res (2021).
F. Bondioli, , L Barbieri, T. Manfredini, Grey ceramic pigment (Fe, Zn) Cr2O4 obtained from industrial fly-ash. Journal of Tile & Brick Int., (2000), 16, 246-248.
R.Borinaga- Treviño, J. Cuadrado J. Canales, E. Rojí, Lime mud waste from the paper industry as a partial replacement of cement in mortars used on radiant floor heating systems, Journal of Building Engineering Available online 13 March 2021, 102408.
A. Carlos, I. Masumi, M. Hiroaki, M. Maki, O. Takahisa, The effects of limestone aggregate on concrete properties. Construct. Build. Mater., (2010), 24 2363–2368.
X. Elías, Reciclaje de residuos Industriales. Residuos sólidos urbanos y fangos de depuradora. España: Díaz de Santos,( 2009).
D. Eliche-Quesada, F. A.Corpas-Iglesias, L.Pérez-Villarejo, F. J. Iglesias-Godino, Recycling of sawdust, spent earth from oil filtration, compost and marble residues for brick manufacturing. Construction and Building Materials, (2012), 34, 275 .
European Commission. Report from the commission to the council and the European parliament on implementation of the community waste legislation. COM 2006, 406 (final, Brussels), (2006).
P.T. Fernando, C.G. Joao, J. Said, Durability and environmental performance of alkali-activated Tungsten mine waste mud mortars. J. Mater. Civ. Eng. 22 (9), 897e904 (2010).
S.M. Hameed, A.S. Sekar, Properties of green concrete containing quarry rock dust and marble sludge powder as fine aggregate. ARPN Journal of Eng. and Applied Scie. (2009), VOL. 4 (4) 83–89.
C. Ince, Reusing gold-mine tailings in cement mortars: Mechanical properties and socio-economic developments for the Lefke-Xeros area of Cyprus. Journal of Cleaner Production, (2019), 238, 117871.
T. Kaosol, Reuse Water Treatment Sludge for Hollow Concrete Block Manufacture. International Concrete on Science. Technology and Innovation for Sustainable Well Being (STISWB), (2009), pp. 23–24.
J. Kiventerä, L. Golek, , J. Yliniemi, V. Ferreira, , J. Deja , M. Illikainen, Utilization of sulphidic tailings from gold mine as a raw material in geopolymerization. International Journal of Mineral Processing (2016).
K. Kunt, Utilization of Bergama Gold Tailings as an Additive in the Mortar. Celal Bayar University Journal of Science, Volume 11, Issue 3, (2015).
F.A. Kuranchie, S.K. Shukla, D. Habibi, Mine wastes in western Australia and their suitability for embankment construction. In: Meehan, C.L. (Ed.), Geo-Congress ASCE. Geotechnical Special Publications, San Diego, California (2013).
H. Li, H. Xiao, J. Yuan, J. Ou, Microstructure of cement mortar with nanoparticles, Compos. B 35 (2004), 185–189,Kustermann A., Keuser M., The influence of steel fibers content in concrete on the plastic properties of composite, 6th Symposium on Fibre-Reinforced Concretes 2004, 1217 – 1226.
Z. Makhloufi, T. Bouziani, M. Bederina, M. Hadjoudja , Mix proportioning and performance of a crushed limestone sand- concrete. Journal of Building Material and Structure (2014), 10–22.
Z. Ming, I. GuoTung-Cha, P. ChiSun, Highly-efficient green photocatalytic cementitious materials with robust weathering resistance: From laboratory to application, J. Environmental Pollution, (2021), Vol. 273, 116510.
S. Roy, GR. Adhikari, RN. Gupta Use of gold mill tailings in making bricks: a feasibility study, J. Waste Manag Res (2007), 25:475–482.
N., Toubal Seghir, M. Mellas, Ł. Sadowski, A. Krolicka, A. Zak, The Effect of Curing Conditions on the Properties of Cement-Based Composites Blended with Waste Marble Dust. JOM (2019), 71, 1002–1015.
UNE EN 772-1, Methods of test for masonry units – Part 1: Determination of compressive strength (2002).
C. Vandna , N. Satya Pal , Pt-sensitized MoO3/mpg-CN mesoporous nanohybrid: A highly sensitive VOC sensor,J. Microporous and Mesoporous Materials. Volume 315, 110906.
K. Youngjae, K. Minseuk ,S. Jungsoo, P. Hyunsik, Applicability of gold tailings, waste limestone, red mud, and ferronickel slag for producing glass fibers. Journal of Cleaner Production, Volume 203,(2018). Pages 957-965.
Z. Zhao, M. Benzerzour, N. E. Abriak, D. Damidot, L. Courard, D., Wang, Use of uncontaminated marine sediments in mortar and concrete by partial substitution of cement. Cement and Concrete Composites, 93, (2018), 155-162.
Descargas
Publicado
Número
Sección
Licencia
1. Los autores conservan los derechos de autor y garantizan a la revista el derecho de una Licencia Creative Commons Atribución - Nocomercial 4.0 Internacional que permite a otros compartir el trabajo con un reconocimiento de la autoría y uso no comercial.
2. Los autores pueden establecer por separado acuerdos adicionales para la distribución no exclusiva de la versión de la obra publicada en la revista (por ejemplo, situarlo en un repositorio institucional o publicarlo en un libro).
Salvo indicación contraria, todos los contenidos de la edición electrónica se distribuyen bajo una licencia de uso y distribución “Creative Commons"
